Laurel Electronics provides digital panel meters / controllers, totalizers, counters, loop-powered meters, temperature meters, for all types of transducers or process indication & control.

Laureate Series Digital Panel Meters

Price List & On-Line Order Form

Ordering Guide

Programmable 1/8 DIN-size meter / controllers for DC & AC RMS voltage & current, process, strain, potentiometer follower, load cell, microvolt, scale meter (weight), thermocouple, RTD, and quadrature (position & rate).

To configure and price out an instrument, select Quantity, press on the radio buttons below, then on "Add to Basket. If you wish to construct a model number so that your company can issue a purchase order, combine the radio button selections to create a model number in this format: L10010DCV1. This example calls out a Laureate panel meter with a standard main board with green LEDs, 85-264 Vac & 90-370 Vdc power, no setpoint output, 0-20 mA & 0-10 V analog outputs, no digital interface, and a DC signal conditioner set for ±200.00 mV. Includes plug-in screw terminals.

DPM Type:

L Digital Panel Meter

$210

Main Board:

	1 Standard Main Board, Green LEDs	NC
	2 Standard Main Board, Red LEDs	NC
	3 Extended Main Board, Green LEDs	$40
	4 Extended Main Board, Red LEDs	$40

Note: Extended capability is required for custom curve linearization or for display of time rate of change, such as flow rate from changing tank level or acceleration from changing speed. Not applicable to temperature.

Power:

	0 Isolated 85-264 VAC & 90-370 VDC	NC
	1 Isolated 8-28 VAC & 9-37 VDC	$30

Setpoint Output:

	0 None	NC
	1 Dual 10A Contact Relays	$80
	2 Isolated Dual Solid State Relays	$55

Analog Output:

	0 None	NC
	1 Isolated 0-20mA & 0-10V	$90

Digital Interface:

	0 None	NC
	1 Isolated RS-232	$60
	2 Isolated 485	$80
	3 Isolated Parallel BCD	$105

Signal Input:

Process Signals (e.g., 4-20 mA, 0-5 V)
	P Default Scaling 4-20 mA = 0 - 100.00	NC
	P1 Custom Scaling	NC
In the write-in field of your invoice, specify min input, min reading; max input, max reading Strain Gage, Potentiometer (4-wire ratio)
	SG Default Scaling 0 - 200 mV = 0 - 100.00	NC
	SG1 Custom Scaling	$10
In the write-in field of your invoice, specify min input, min reading; max input, max reading. Full-scale input is 20-500 mV. Excitation is 10V for up to four 350-om load cells Note: The same DC signal conditioner board can be user-configured for DC Volts, DC Amps, process, or strain. It is precalibrated in EEPROM for all DC Volt and DC Amp ranges listed.

Add-on
Options

	BL Blank Lens without Button Pads	NC
	EB Extra Bright Red LED Display	$30

FLW, Inc - 3505 Cadillac Ave - Bldg E - Costa Mesa, CA. - 92626 - USA - Ph (714) 751 - 7512 - Fax (714) 751 - 0213